PowerFLARM Portable
The PowerFLARM Portable has a built-in display and control knob, attached antennas, and internal battery. It can also be powered with external power. It is the perfect portable solution for use in multiple gliders and towplanes. A microSD card slot is included in the front of the unit for flight log and other data transfers. I think the photo makes it look larger than it really is.

To get a good feel for its size I highly recommend printing and building the PowerFLARM Paper Model. Be sure to set the page scaling to "None" (not "Reduce to Printer Margins" or "Fit to Printer Margins") when printing it.

Features:	FLARM functionality – sending out your position and vector and receiving vectors from gliders in range (about 4 miles) ADS-B Traffic Reception – ADS-B traffic position and relative altitude are displayed on the PowerFLARM display. Mode S Transponders – Nearby Mode S transponders are displayed on the PowerFLARM display. Since direction is not known, the traffic is displayed as a ring around the glider. Mode C Transponders – Nearby Mode C transponders are displayed on the PowerFLARM display. Since direction is not known, the traffic is displayed as a ring around the glider. 2nd FLARM Antenna Port Enabled (2nd antenna not included) Audio Output Enable - The built-in audio output port for sending FLARM alarms (beeps only) to an aviation headset is enabled by default. GPS Flight Recorder - Accepted by OLC, no IGC Approval or task declarations
Options:	IGC Enable, $95, required if you want to use it to validate badge and record flights Logger Calibration - The PowerFLARM Portable is delivered without a logger altimeter calibration data sheet. I can calibrate it before shipment for $75 ($95 normally). You can select the optional calibration at check-out. Engine Noise Level (ENL) Recording Enable, for motorgliders, $170 Garmin TIS Interface Enable - This can be enabled for $95. Cable-PFLARM-Pwr-RJ45-2, Cable with RJ45 8-pin connector to for connection to a PowerFLARM's RJ45 port, 12V power leads are also provided for powering the PowerFLARM with 12V. Cable-PFLARM-Pwr-Barrel-2, Cable with male barrel connector for connection to the Portable's 12V female power port, 12V power leads are also provided for powering the PowerFLARM with 12V. Cable-PFLARM-Pwr-RJ45-RJ12-1 - Cable, PowerFLARM RJ45 port to remote FLARM display, 12V power leads are also provided for powering the PowerFLARM Portable with 12V.
Dimensions:	Main Unit: 94 x 94 x 46mm (3.7 x 3.7 x 1.8 inches) Total Height from the base of the FLARM to the top of the FLARM antenna: 125 mm (4.92 inches)
Sensors and GPS:	latest technology pressure sensor integrated 50-Channel GPS receiver optional ENL Engine Noise-Level sensor for motor-gliders
Display:	sunlight readable active matrix TFT display resolution 132 x 176 pixels 2" screen size 180° viewing angle day and night mode
Power and batteries:	6 interchangeable AA-batteries (all types) adaptive battery loading circuit with temperature monitoring (NiCd and NiMh batteries) usable without batteries (10 to 30V DC aircraft power) lasts up to 8h on one charge (depends on traffic volume)