RAM® Form-Fit Cradle for Garmin GPSMAP 76C Series, 96 & 96C
Works great with the RAM-A-101 mount extension below.

Note: The Garmin GPS 72, GPS 76, GPSMAP 76 and GPSMAP 76S will not fit this cradle. These units require the RAM-HOL-GA6U cradle.

The RAM-HOL-GA14U consists of a high strength composite cradle and hole pattern that will allow the attachment to all RAM components or mounts that contain the universal AMPs hole pattern. Compatible and interchangeable with a wide range of popular RAM Mounting products, this cradle is ready to compliment your GPS and become the most useful accessory in your vehicle. Included is a set of two nuts and bolts to connect the cradle to any RAM components or mounts that contain the universal AMPs hole pattern.

SPECS

Hardware included:
(2) #8-32 x 1/2" Machine Screws
(2) #8-32 x 5/8" Machine Screws
(2) #8-32 x 3/4" Machine Screws
(2) #8-32 Nylock Nuts

Hole Pattern:
2-Hole AMPS: 1.912"

Materials: 
High strength composite

Weight:
0.19 lb

Customer Feedback
"The RAM-HOL-GA14 fits the GPS-96C just fine, and two of the three ports on the back are available when the GPS is in the mount (the antenna port and the USB port).  However, the serial port (the round Garmin plug) is covered by the mount.  To access it without repeatedly flexing the mount to remove and reinstall the GPS, one would have to cut a section out of the back between the lower two mounting holes, right where it says 76C/76CS on the inside face of the mount.  Due to the odd orientation of the plug, the cutaway must be flared to the left as you look at the back of the mount to accommodate the cable which goes down and to the left as you look at the back of the GPS."
However, The owner of RAM sent me a response to the statement above, "I have a GA14 on my boat with the serial cable and it works fine."  
They must be using different serial cables...