LXNAV FlarmLED
The new FlarmView is a very small and simple display for use with FLARM and PowerFLARM products. It can display FLARM traffic warnings. It can also display warnings for ADS-B traffic and Mode C and Mode S transponder traffic. The user-interface consists of a single pushbutton which is easy to use in flight. The built-in speaker is very loud - which is important for traffic alerts.

Very Small Size
Note: This unit is very small. From the images, you may imagine that it is about the same size as a FlarmView display. It is only about 2/3 as wide as a FlarmView rectangular display - being only 1.65 inches (42 mm) wide and 0.98 inches (25 mm) tall. The dimensions are listed below and shown in the drawing at right. Don't get me wrong - small is good - it will fit into small places on your panel that other displays wouldn't fit. The user-interface is so simple that it is very easy to read at a glance - despite its small size.

Overview

• 12 bright 2-color LEDs indicate the direction of other aircraft
• Single push-button - for adjusting audio volume, settings, etc.
• Vertical position is displayed with 5 LEDs
• Very loud audio warning
• Near mode - displays targets in yellow if they are nearby but not a threat
• Configurable baudrates
• Double-seater configuration - setup on display as the master and all others as slaves
• Compatible with all FLARMs and POWER Flarms
• The small size is easy to install in the tightest of panels
• Supports all FLARM warnings found in the FLARM 6.0 specification
• Displays non-directional traffic warnings - (Mode C and Mode S transponder traffic) - when connected to a device such as a PowerFLARM Core which supports those traffic types

Features

• Extremely bright bicolor LEDs
• Pushbutton - to adjust beep volume
• Near mode function
• PCAS warnings - undirected
• Adjustable baudrate
• Slave mode (1 display is master, all additional displays are slaves)
• Progress indication (during flight transfer, firmware updates, obstacle updates...)

Input and Output

• Serial RS232 input/output
• Pushbutton
• 12 bicolor LEDs for direction
• 5 LEDs for vertical angle
• 3 LEDs for GPS, Rx and Tx indication

Power

• 3.3V DC
• 10 mA @ 12V (120mW)
  

Size and Weight

• Size: 42 x 25 x 5 mm (1.65 x 0.98 x 0.20 inches)
• Weight: 10 g (0.35 ounces)

Included

• FlarmLED display
• Power/data cable with RJ11 connector for connection to the back of the unit and RJ45 connector for connection to FLARM or PowerFLARM display port,
  Cable Length: 24 inches (Let me know after ordering if you need a longer cable.)
  
• Printed manual

Manual
Details are available in the FlarmLED manual which is available here.